Search results

Just sold my 2009 Mazda6 Sport a couple weeks ago. I have my K&N air filter ( 33-2395 ) for sale, only in the car for about a month. I'll ship it to you in the lower 48 for $25.00 [removed]

Re-set the ECU Last night, I disconnected the ( - ) cable from the battery for about 45 minutes, then re-connected it. The fault light is gone, and the car is running perfectly. Must just be like doing a hard boot on my computer. I also phoned the dealer, and told him that I no longer...

Last week I inadvertantly let the car battery drain completely down. So I got the battery re-charged full, then started the car and began driving into town. That's when I noticed the Keyless Ignition Light by the speedometer was ON and steady RED. No buzzers or flashing, or any other...

I personally see no need to get an alignment. You've looked at your tires, and they're not indicating any needs. Get your new tires on and enjoy

I have a 2009 Mazda6 Sport Touring

Silver 2009 Mazda6 S Touring Age: 64 Lowell, Oregon Retired FAA Safety Inspector

Perhaps the easiest mod I've ever done. Jacked up the right front about 8", removed four screws holding a plastic cover, and then just bent the plastic down about 6", exposing the OEM horns. Removed them, installed the new WOLOs using the same two bolts. The WOLOs have two terminals, and they...

Really great site ~~ scuff looked exactly like mine. I'll work on mine over the weekend. Thanks

Yep, the stock 18" wheels on my 6s Touring

Yesterday, I was doing a U-turn on our street, and misjudged the clearance of my frornt wheel and the curb. It rubbed for about 6" but only surface scrapping. Hard to see, kinda like a rough fingernail, and zero damage to the tire. I'm wondering if I can safely take my little orbital sander...

e-Bay has the Autopage BPS-4 for $60.00 shipped. I've installed these in a Mazda3 HB and in my Mazda6. About a two-hour job, taking my time, and doing good work.

Thank you, I just used this procedure on my third remote, and it works very well

Employing the use of a relay is never wrong. My reasoning for not using one is that I don't think the electrical circuit of the horn will be over-taxed by my occasional short toot. If, on the other hand, I laid on the horn for 90 straight seconds at a time, I might pop the circuit breaker. My...

I just installed a Wolo (low) wired in series with the OEM horn. It sounds off rather nicely, and for a total cost of $20.00 and an hour of my time.

I purchased my Mazda3 HB last Monday. This morning I installed a single low-tone Wolo horn, wired in series with the OEM horn. Took less than an hour, and now the horn sounds a little more like a big man <G>

PM Sent