JBR rear sway bar

[cameradude]

Can you clarify of parts for putting in MS3 RSB? You are suggesting Moog sway bar end links that are bigger? So not Moog one's for a M5 but one's for specifically MS3??? I was going to order these

http://www.rockauto.com/catalog/moreinfo.php?pk=1287952&cc=1444871

Mind posting a part number for the Moog rear sway bar end links?

And I was going to get these Moog bushings
http://www.rockauto.com/catalog/x,carcode,1444871,parttype,7624

Only going with the Moog bushing cause I don't want to get under and grease them often. Unless there is a polyurethane one that requires very minimal greasing.

 

[MR6]

The factory MS3 links fit the Mz5 so any aftermarket link for the MS3 will fit. they pretty all do, but make sure they come with the nuts. The factory Mz5 nuts for connecting the end link to the sway bar do not fit an MS3 end link.

That link is for Mz5 bushings. I don't recall if the rear bushings were the same spec for both cars but you should order bushings for the MS3 if your plan is to install an MS3 sway.

 

[MR6]

Just got this response from Tri-Point:

Our heavy duty Brackets and Urethane bushings are $47.00 for the set. Shipping is $10-15
Parts are in stock.

I just installed the MS3 rear sway with new oem brackets and i gotta say, the oem MS3 brackets look just as thick as the beefy tri-point ones they want $47 for...oem = $6.12 per! See a penny, pick it up!

top one is MS3



Tri-Point