Recent content by Logan

I bought the car from post #1, I am picking it up on Sunday.

believing those production numbers/times is like believing Canada was only getting 250 MSP's... Mazda Marketing Dept. working hard!

I usually measure 6.4 seconds 0 - 60 using my palm OBDII scanner. Stock boost, ground controls. 60 is just before the rev limiter in 2nd.

I believe unless JIC has changed them... they do not fit without spacers or 50mm offset wheels instead of 55mm offset.

Why-o-why don't they bring it to Canada.... sigh

I run with no front bar (endlink removed) in my MSP in the winter.

??? It's been fine for me all morning...

Yes it's needed. You're changing your struts and springs, you will see as you drive the car the first time, I guarantee your alignment will be way off. Book your alignment for as soon as you can.

yes

This shouldn't apply to the JIC's, completely different setup.

Did the colours have any chinese historical/cultural representation? I was trying to figure out if they meant something, or were just for show.

Yes, full stock length MSP bumpstops. I think I was too low on the GC's and the bumpstops were the spring, instead of the spring.

I can't remember the last time I wasn't on pavement. I greased them up really good the last time I replaced them. The passenger side one is so bad right now that I reached in and pulled a chunk off. It clunks really loud, it's the metal spring hat contacting the stock upper mount.

I have an 03 MSP, still running the stock front bar, am not very low, and am about to replace my strut bearings for the third time this summer. I talked to the guys at Ground Control, and they suggest the strut bearings are being destroyed due to too much load on them. They thought maybe I'm too...

Let me know when you destroy your first strut bearing. And the second... and the third.....