C CodyScott Member : mazda proteg5 May 26, 2014 #1 The old rotors were old and rusty so I decided to replace them. They were ceased on there. Half a can of pb blaster later I got them off with a dead blow put the new ones on finished the break job but the rotors won't sit flat... What do I do?
The old rotors were old and rusty so I decided to replace them. They were ceased on there. Half a can of pb blaster later I got them off with a dead blow put the new ones on finished the break job but the rotors won't sit flat... What do I do?
T tweety2300 Member : 2001 mazda protege mp3 May 26, 2014 #2 The tires hold them on. Do they sit flat if you make them?
C CodyScott Member : mazda proteg5 May 26, 2014 #3 There's corrosion from the old ones and the way it popped off it sits on an angle
K kamesama980 Member : 2002 Protege5 Jun 1, 2014 #4 Clean the corrosion off. Wire brush, sandpaper, no grinding. Is it really that hard?
