hello all.
ok picked up a 2003.5 msp, has good but of mods,
but current issue:
yesterday idle was bad, as soon as it is above 1000 rpm it was fine and oil pressure lamp went off, but under idle lamp was on and it would drop to almost 0 rpm and die once in awhile,
today, started fine and drove maybe 2 blocks and it was bucking hard at low rpm 1-3000, after 3k it was fine, but pulling out was a b****.
then in a few blows it just shut off and wont start, just cranks and cranks.
now code says cam position sensor and seems to make sense just wanted to post here before i went that route
thanks for any advice
ok picked up a 2003.5 msp, has good but of mods,
but current issue:
yesterday idle was bad, as soon as it is above 1000 rpm it was fine and oil pressure lamp went off, but under idle lamp was on and it would drop to almost 0 rpm and die once in awhile,
today, started fine and drove maybe 2 blocks and it was bucking hard at low rpm 1-3000, after 3k it was fine, but pulling out was a b****.
then in a few blows it just shut off and wont start, just cranks and cranks.
now code says cam position sensor and seems to make sense just wanted to post here before i went that route
thanks for any advice