So My wife ordered a set of the weathertech floor liners for me for my birthday. I was actually looking to go with the 3D maxpider ones off amazon since they were cheaper, but I thought, it doesn't really matter. We have weather techs in her audi and they fit great and have held up well. The liners showed up yesterday I did a test fit with the drivers side and I have to say I am not impressed with the fit at all. I expected much better for the price we paid for them. let me try to explain the issues here and maybe someone can help with the questions or has had similar experiences.
1) The right grommet in the drivers area seems like it only in the carpet and not attached to anything underneath and it feels like the grommet is sitting on top of some sort of plastic under the carpet, perhaps the duct for the floor heat/AC under the drivers seat. Does anyone else have this issue? Because of this the liner does not what to lay down in the right rear and the fit is about 1" to 1.5" off the carpet in that corner.
2) The left front area of the liner does not sit up against the outer part of the footwell just before it meets the dead pedal area, again its pushed away by about an inch. Seems sloppy to me but it could just be it needs time settle in to the area and relax after being stuffed into a box.
3) The area around the gas pedal is disappointing to say the least. The little lip at the base of the pedal is very short and does not look like it would catch much water or debris. It also sits a ways back from the pedal leaving a good "channel" for anything on the bottom of my shoe (ie, snow, slush etc) to run down the pedal and onto the carpet, not the liner. And the liner doesn't cut into the pedal very well from the left side, they're is quite a bit of space that could have been covered up.
4) The Dead pedal coverage only goes half way up the dead pedal and the liner will not fit with my make shift thread I put there. I have to remove the thread I velcroed in place and my foot rests mostly on the part that is exposed.
Has anyone else seen these issues or am I just crazy? Are the 3D maxpider liners any better of a fit? And what about the grommets, they seem like they should be attached to something or at least sit a bit further down against the floor pan. Thanks for the help.