- :
- Central Virginia
- :
- 2019 CX-5 Reserve
The manual infers that the beep volume can be changed, but I cannot tell if it means only when opening it using the fob.
This is from Page 3-14:
Personalization Features on page 9-12 says this can also be changed from the center display.
This is from Page 3-14:
A beep sound is heard for confirmation when the doors and the liftgate are locked/unlocked using the request switch. If you prefer, the beep sound can be turned off. The volume of the beep sound can also be changed. Refer to Personalization Features on page 9-12. Use the following procedure to change the setting.
1. Switch the ignition off and close all of the doors and the liftgate.
2. Open the driver's door.
3. Within 30 seconds of opening the driver's door, press and hold the LOCK button on the key for 5 seconds or longer (All of the doors and the liftgate are locked and unlocked when the LOCK button on the key is pressed and held for 5 seconds.). The beep sound activates at the currently set volume. The setting changes each time the LOCK button on the key is pressed and the beep sound activates at the set volume. (If the beep sound has been set to not activate, it will not activate.) 4. The setting change is completed by doing any one of the following:
-Switching the ignition to ACC or ON.
-Closing the driver's door.
-Opening the liftgate.
-Not operating the key for ten seconds.
-Pressing any button except the LOCK button on the key.
-Pressing a request switch.
Personalization Features on page 9-12 says this can also be changed from the center display.
Last edited: