Recent content by michiganspeed

I will pm you...

no, i was not able to trouble shoot as necessary. I needed to start the drive back to davenport from detroit shortly after picking the car up. Are you there on weekends?

I threw a rod and replaced the enigine w/ a 30k motor from protegegarage. I also added the joep manual boost controller and the turbohoses intake. the engine itself runs fine but it will not boost properly...as the boost pressure moves approaches the positive it cuts out/hesitates really bad...

Out... I am out for saturday...Wife has to work, so i have the kids...have fun everyone!

Motor Mounts i replaced the front/rear/side motor mounts with the highest durometer (i think it is 90...?) and my car vibrates ALOT below 1200 rpm. I enjoy it though and i have no wheel hop. As for exhaust first, that is what i did, and i think that is what shot the stock motor mounts. I...

1. tunersteve (Steve, 2007 MS6 ) 2. jdub260 (Chris, 2006 MS6 or 2007 Fusion) 3. martispeed (Anthony, Blue Mp3) 4. Greasemonkey524 (Rob, 03 MSP) 5. goldwing2000 (Kane, '05 this or '04 that) 6. willowofwisp( dave 07 mz3 sedan 7. wisp friend (joe 350z) 8. wisp friend (srt-4 stage3) 9. wisp friend...

thanks...i will let you know.

cool thanks.

I need a new rear motor mount. I tried to follow the link in the aftermarket thread, but it is a dead end. Is there another reasonable source for the ureathane (spelling?) mount? Also, i need new front wheel bearings, is there any special brand, or can i get the ones from murrays (they are...

This could be my problem as well...had autozone read the CEL code and he said it was a bunch of things...including a vacuum leak...

Ok,...just for the record...I did search a little for these. First, ever since i but on the EBC sloted rotors and green pads, i am gettting a nice hum out of the front end when i turn. Also my ABS and Brake light has been on since the change. My brake fluid is full. Is there a sensor that i...

1. tunersteve 2. jdub260 3. Albert 4. Yaggie1 5. SlideWRX 6. Xcelr8to1320 7. goldwing2000 8. jaw307 9. blackmica3 10. Winty87 11. neit_jnf 12. jonlong 13. Turbotom 14. DaveB 15. Joe RX-8 16. Japan8 17. kfcuno 18. jflash 19. jfvhpilot 20. Will P Rob 21. Entense 22. Bluesultan 23. Perro del Sol...

I might take mine off for winter. i keep hitting the fuel cutoff.

i got the rotors and pads from Ken at mazda3.com. Very good customer service. Very happy with the product and the service

I just got mine stuff (dimpled rotors and green pads) today. Can't wait to get them on. But,...the rotors i got are 11" in diameter, isn't that larger than stock? I just haven't looked but they just appear much larger than stock.