Here's a pic of mine.
Did the install myself. Here are the instructions I followed: http://krystmsgarage.com/?page_id=16
Take your time, don't rush. Luckily for me I have a spare set of headlights and was able to do this mod w/o sacrificing my car for the day.
I do have some condensation in...
Make sure you attach the fairing to the load bars as shown below:
The two inner attachment points are at the end closest to the fairing whereas the two outer ones, closest to the load bars. Hope this makes sense.
Looks good. I know some people use plugs from a hardware store http://forums.nicoclub.com/diy-license-plate-bumper-plugs-t369523.html OR spend the bucks and get them from here http://www.bumperplugs.com/BPindex.html
I needed to replace one of my foglight units and found out that the fog lamp itself is exactly the same in the RX-8's. It was available in 3 different colors: clear, blue or multi colour tints. It was cheaper to get it off eBay than get it thru JapanParts.
Thx for the complements! I wish I was running coils but alas no. I picked up the MS Sport springs and camber kit from a local member that was parting out his car. I'm going to wait a couple of days b4 I get an alignment done after every settles.
The rear bar is an eibach which is 26mm. I was...
I posted this question in the mazda3 section but to no avail, so I thought I'd have better luck here.
I picked up a OEM Protege fog switch part# D342-66-4BO and am wondering if someone can please tell me what each of the 4 male connectors on the back are hooked up to. (I will be using the...
I'm in the midst of installing some CCFL's on my car and plan to use a switch. There have been members that have used a fog switch from a protege5 and was wondering if anyone can tell me how they wired it up.
Thx
There is a TSB for it..not sure if you qualify unless you have extended warranty:
http://www.finishlineperformance.com/pdf/mazda3/bulletin/02-002-06-1589.pdf