Tinting installation?

[BlackCherry]

Hey guys, I just have a quick question, hoping someone could give me a hand. I previously ordered a set of turn signal tint from bluebatmobile. The quality was good, everything was nice. But when I applied the tint the edges got wrinkled cause of the curve of the tail light. The tint is perfectly flat so it doesn't bend with the light. I'm ordering a new set from them soon, hoping to possibly have some better luck with these. Can anyone give me some tips as to not wrinkle it. I emailed them about it, but they didn't really supply me with a clear response.

 

[MazdaSpeeder]

I assume you're talking about the round tint cutouts...I had them wrinkle as well, although I used a hairdryer and it helped some.

 

[justanothermp5]

heat gun works alot better then a hair dryer
just use the lowest setting and slowly heat the tint when its wet, it'll shrink and take the wrinkles out
takes a while to get it right but its worth it

 

[BlackCherry]

heat gun works alot better then a hair dryer
just use the lowest setting and slowly heat the tint when its wet, it'll shrink and take the wrinkles out
takes a while to get it right but its worth it

Oh! Ok, cool I didn't think of that, thanks for the advice!