tapping into brake booster line?

[dfsho]

I am installing my hks ssqv and am re-doing my vac lines.
I have to tap into the brake booster line to run lines for my bov and bpv. (I am using 505s bov/bpv set up.

My question is how should I do it?
Yes, I know about the check valve but I can't seem to find it.
The line feels all the same through out.

I know about the vacuum block but it is rather expensive and I don't understand how to connect it.
The brake booster line looks to big to me for that vacuum block.

Any help would be greatly appreciated!

I was told there was a how-too but I could not find it.

Thanks!
Dfsho

 

[Silverspeed2015]

you can get cheap vac blocks, but the check valve is about 6 inches or less from the brake booster.

 

[MANDO]

When I had my HKS I just tapped it into the Fuel Press Regulator Vac source and it ran great with no stall issues.

 

[dfsho]

When I had my HKS I just tapped it into the Fuel Press Regulator Vac source and it ran great with no stall issues.

Where is that?

 

[tricky]

http://www.mazdas247.com/forum/showthread.php?123711609-Kill-your-Turkey-V.2 post #20 shows a vac block on the BB line

 

[nato]

Check out mcmaster. You can get the vacuum block and all the fittings for the price of just the vibrant block. Don't forget teflon tape for a better seal on the fittings.

Post #13 has part numbers:
http://www.mazdas247.com/forum/showthread.php?123735342-need-help-with-vacuum-block

 

[dfsho]

Thank you!! all your help was greatly appreciated.
I feel dumb now. Its way less complicated than I thought.

 

[MANDO]

Thank you!! all your help was greatly appreciated.
I feel dumb now. Its way less complicated than I thought.

Thats how you learn bro, by asking questions and doing the right research. I would also recommend the VAC block for convenience & reliability like the other guys mentioned.