remove inner door panel, with power locks

[pat_smith1969]

Ok so I am in a bind.
I am trying to install deadening on the doors of my Speed3 with power locks. I have the pretty inner panel off, and have removed, mostly, the inner panel (that holds the power window motor). There are wires running across the plastic inner door panel and to the pwr door locks. I can not for hte life of me figure out how to get the molex off the lock motor. without remoing that molex I cannot get the inner plastic panel off enough to deaden the door.

Does anyone know of a link to do this? I have found several but none go into how to work around the power locks.

my car is out of comission until I get this done.

 

[pat_smith1969]

well I figured it out. It was a REAL pain though, took almost an hour. I have some pics I will post later.

 

[kvndoom]

C'mon! Where are the pics?!?

 

[halo0]

What was so hard about undoing a wire connector? Sometimes the clips are a b**** but not hard to figure out usually.

I want to deaden my doors too so this will be useful info.