msp turn signals not working

[unwound]

headlights work
parking lights and taillights work
fog lights work
reverse lights work too

but not the turn signals or the hazards.

i was de-passive arming my alarm (flipping dip switch 2 to factory setting);
got brain back in and went driving-- went you use turn signal and i got nothing. .

anybody have any ideas what the problem could be? i think my hazard switch on might be bad, but i don't know for sure.
i checked all the fuses and all were ok, but don't know if and/or where the relay is located to check.

 

[boostisgood]

Under da hood. Check that box, and then fix the alarm brain.

 

[Eric-BlackMSP]

Prolly the relay or the switch itself.

I hate problems like this, it is usually something really easy and it takes forever to find it!!!!!

Make sure everything is connected, re check those fuses. I would prolly buy the repair manual for a protege, it has all the wiring diagrams, and is usefull in the future.

-Eric

 

[unwound]

Under da hood. Check that box, and then fix the alarm brain.

boost if you are reffering to the fuse box under the hood, i did check and all was good. also what would i need to do to "fix" the alarm brain?

 

[unwound]

pulled the center console off to check the switch.

took the 'ole p.o.s. voltmeter to it and when the switch is off
there is a reading from the harness, but when it is on there no
reading from the harness.