HELP taking out a 5spd trans out of a '99

[bidi]

I need help taking the transmission out.

Seams like I took all the bolt out, and it's still not budging.

I have the front mount, rear mount, and side mount removed,
Cross member bar... or what ever the front mount is located on is removed,
Axles disconected,
shift lincage disconected,
electrical sensors disconected,
slave cylinder removed,
I though I took all the bolts of the starter, but it's not comming out either, whf?

I can't see sh*t over the intake manifold, and that's a pain in the a*s to remove, too.

Am I forgeting something?

P.S.
The car is a 1999 Mazda Protege DX
1.6L DOHC with 5spd manual transmission

 

[bidi]

Any help would be appreciated.

Already have new flywheel, pressure plate, clutch, and some bearings.
Looks like the rear transmission mount is all kinds of fu*ked up too, so need to pick up one of those too... no wonder it was making noise.

 

[Dpwhitehead1]

alright bro.. here you go!!

http://www.mazdas247.com/forum/showthread.php?t=67599&highlight=how+to+remove+5+speed

absolutely everything you need is there. any more help, just pm me bro!

 

[bidi]

Thanks, that should help me a lot.
Unfortunately I found that my rear tranny/torque mount is busted too, and a new one won't be here till next week... so the project is geting postponed
I'll have to drive my stripped teggy for the next five or six days.

 

[protege321]

i just finished this protject, make sure you get the oil seals from mazda. the part number for them is on the write up.. i didnt and it delayed my project 2 weeks. fairly straight forward project.