Dyno'ed my Mazdaspeed 6

Went to the Dyno with CSC (ChicagolandSRTclub), decided to get a base line before I start modding. It was a Mustang AWD Dyno. Here is my sheet. Only mods are a Magnaflow catback.

2006Mazdaspeed6Dyno.jpg


223awhp 242awtq was the best pull. Should have a vid up in the next couple days. Not sure how this compares to other MS6's at a mustang dyno. But it was higher than I thought it would be.

The meet was a great turn out, not everyone in the club owns SRT-4's any more so it pretty cool to see everything dyno. For fun here are some other cars dyno numbers, that dyno'ed that day.

06 GLI (Stock) - 150whp
05 SRT-4 (Intake, exhaust, BFMIC, WG) - 215whp
06 Mustang GT 5-speed (93 Tune, exhaust) - 245whp
08 Caliber SRT-4( Stage 1, WG, BMFIC, Map Clamp) - 285whp
05 Corvette Z51 M6 (B&B LT's, Full exhaust) 301whp
03 SRT-4 (Stage 3, Bolt Ons, Race Gas) - 325whp
06 SRT-8 300C (93 Tune, intake, exhaust) - 351whp
04 SRT-4 (Big Turbo(off beat size) bolt-ons, 29psi race gas) - 385whp
04 SRT-4 (50 trim, cammed, bolt ons, pump gas) - 397whp
07 SRT-8 300C(93 Tune, 100 wet shot) - 417whp on juice, 340whp off

Overall it was a pretty good turnout.
 
Last edited:
Sweet!

Actually, I've been wondering what the baseline numbers on these cars are for a while. The fact that you got it done on a Mustang Dyno makes it even better since Surgeline has a Mustang. I put down 274awhp & 314 lb/ft of torque at 17psi. So, with everything I got, I gained around 51hp and 71 lb/ft! Not bad!

Nice numbers, man!
 
Good numbers! I have MS CAI and pulled about 220 hp and 270 tq on a mustang dyno, on a hot texas summer day.
 
Back