May I ask some help for adding cruise control to my European Mazda 5, 1.8 TX, 2008 model?
Going through xilian number of posts, I understand that I need:
A new brake switch B7N7-66-490.
and new buttons on my steering wheel CC48-66-4M0 This is all OK.
When I get my dash lit with odometer, I have the CRUISE light on.
However, I have only 2 wires at the brake switch (!), and my wiring harness is the CD8567SH0 for the brake switch. This is called short coord in the EPC.
I had an old wiring diagram which showed only 2 wires. Other posts and pictures talk about 4 wires.
Can anyone send me the correct wiring diagram? Or can anyone help me with the issue? Shall I replace the harness, or there is still a way to do it? Do I need the four wires at all at the brake switch?
I checked the EPC, the steering wheel switch CC48-66-4M0 and the brake switch B7N7-66-490 are available for the 1.8 litre TX. However missing 2 cables are very disencouraging.
Many thanks in advance
Laszlo
Going through xilian number of posts, I understand that I need:
A new brake switch B7N7-66-490.
and new buttons on my steering wheel CC48-66-4M0 This is all OK.
When I get my dash lit with odometer, I have the CRUISE light on.
However, I have only 2 wires at the brake switch (!), and my wiring harness is the CD8567SH0 for the brake switch. This is called short coord in the EPC.
I had an old wiring diagram which showed only 2 wires. Other posts and pictures talk about 4 wires.
Can anyone send me the correct wiring diagram? Or can anyone help me with the issue? Shall I replace the harness, or there is still a way to do it? Do I need the four wires at all at the brake switch?
I checked the EPC, the steering wheel switch CC48-66-4M0 and the brake switch B7N7-66-490 are available for the 1.8 litre TX. However missing 2 cables are very disencouraging.
Many thanks in advance
Laszlo