ok guys as promised the refined endlink:
First off before you say anything yes i know i am missing a jam nut, it was late when i put in the order and my dumb ass forgot the reverse threaded jam nut.
Anyway as far as parts are concerned, its two male endlinks in the 3/8"-24 threading. However one is right threaded the other is left threaded. You will also need jamnuts of the same threading once again right and left threaded. These can all be found at Mcmaster. Looking about $30 or so for enough to make two endlinks (jam nuts come in boxes of several,usually 25, so you can make multiple endlinks after the initial cost). The center rod is the trick though. It can be found at coleman racing as a shifter rod. The one in the picture is 7" long and it is pre threaded on each end for 3/8"-24 threads, one side right other side left, this allows you to loosen the jam nuts and twist the center sleeve to adjust the endlink on the car. Price is 8.75 per rod and your looking at about $18 for them. So all in all for a set of endlinks plus shipping plus mounting hardware your looking around $60ish
btw link to coleman racing is
http://www.colemanracing.com/store/shopdisplayproducts.asp?page=8
I am trying to find out a possible step further and get something with a hex so you can put a wrench on it. I will let everyone know how that turns out.