Search results

Yellow on the left hand side if your heading north, the right hand south (duh), looks like a sign asking 11k in the window. Just sitting at the end of a long gravel driveway. FYI Also, who's up for some wings tonight? I'll be the first round of beers. Come one, come all. And I'll have the...

So I've got my manifold in, and reconnected all my hoses and plugged in everything. When I start the car, it starts a bit rough, then revs very high, then drops down again. It doesn't seem to pay attention to the gas pedal, as I cannot get it to hold a steady rpm. Also, I get a high pitched...

I, because I suck quite alot, managed to lose one of my injector gaskets so I can't finish my intake manifold install. However, just to be sure, I'd like some shots of people's manifold with the engine cover off. Just to make sure my notes line up, as I think I got two hoses confused. Any...

I've got my new p & p'd IM ready to go on, and I've got the stock one almost out of the car. However, it's that damnable EGR pipe that I just can't get off. I sprayed it with PB Blaster and WD40, but no go there. I've got a crescent wrench but it's not getting a good enough grip. Does anyone...

Just curious as to what ya'll are doing the last weekend of August, perhaps that Saturday the 26th? Perhaps some wings can be ingested? Or ribs devoured? Your thoughts my good wisconsonians!

Just curious what ya'll would suggestion I use. :-) Oh, and for my rear bumper sag, any suggestions besides 3M double-sided exterior tape? I test tried out a few pieces, but it doesn't look very good. Granted I haven't fully taken off the bumper, goo b goned the full rear, and looked at the...

http://snakesonaplane.varitalk.com/ nuff said

Looking for some reasonable offers...

As the title says, I would like to find a place around these here parts to port my IM, since I haven't got the tools. Nor have I ported anything, and though I'd like to learn at some point, well, you know. I'm impatient! Suggestions welcome!

So I've got my hands an a p5 intake manifold with the vcis and vtcs removed. However, I believe the stock IM is restrictive still, even with those gone, so my question is, has anyone ported theirs? Any thoughts/ideas would be very welcome.