Recent content by Typhoonk123456

  1. T

    Fogs as DRL (HID headlights - no DRL)

    If you have a separate low beam, high beam, fog, and DTRL relay it shouldn't be that hard. find out which pin on the DTRL relay socket is the trigger, then run that to the trigger of the fog lights relay. DTRL relay may have to be installed for other functionality, so you may have to snip...
  2. T

    How do you remove A pillar on the passenger side on 14 Mazda 5?

    not sure what the clip looks like but maybe it's like this one -> https://www.youtube.com/watch?v=Tvn2cYWX9FE
  3. T

    Power Locks

    wrong forum, but I've had a P5 before. it's actuator motors that have worn out the plastic gears inside. Buy all new from mazda, easy to install.
  4. T

    2010 Mazda 5 Not Starting

    probably didn't plug back in something at the column
  5. T

    Door Ajar light wire from BCM (2007 Mazda 5 GT)

    no 'door pin' connection at the cluster. Have to use the door pins or the delayed overhead light. door pins are a pain because you need 4 diodes and some 10k resistors. or you can find something like this --> http://www.drdetailshop.com/DITMAZDA.htm good luck (I charge so much more when...
  6. T

    Metra 2din Dash Kit - fitment issue

    take the face of the original radio, cut out what you don't need and fiber glass and paint. Good weekend project
  7. T

    What I did to MY09 GT without an amp..and it sounds great to me!

    ever thought about spraying foam inside the frame tubing to quiet sound?
  8. T

    Shudder on braking - 2012 Mazda 5 sport

    warped rotors can be caused by a defect or wear but if your rotors have less than 15,000km on them your calipers may be seizing and causing dragging and unnecessary heat. Make sure the caliper is working, and the slider pins are smooth and not pitted, or rusty. Or they will just warp again.
  9. T

    Remote Start Options

    I'm running a simple Canadian Tire ProStart (AutoStart rebrand), and a idatalink ADS-TB (for transponder interface), and a PAC-TR7 (pulse module) So Lock, lock, lock on my factory remote will remote start my car in my driveway. Next step is to open up the factory remote and see what kinda...
  10. T

    I think my Wolo horns suck

    Will do. I will try and find a nice sounding low tone horn to add to my high pitched factory one. Then use a relay and fuse to supply straight battery power to the horns. (dance)
  11. T

    DIY Third brake Light flasher w/ delay Module (Kahtec)

    Was worried about my little Mazda 5 being rear ended by some of the drivers on a highway. But found this little module that flashes the third brake light 6 times, then stays on. Also will not flash again unless the brake has been released for more than 8 seconds (so it's not flashing all the...
  12. T

    Oem roof rack - NEED fairing or remove ?

    https://www.youtube.com/watch?v=sqwLxewsgTI plan on picking some up to have on hand. So may try this trick on the bars
  13. T

    I think my Wolo horns suck

    add a relay so the horns can get full power from the battery.
  14. T

    a lot of noise

    Try a few tests. 1. is the noise only when the car is running? 2. connect a external antenna to the back of the radio. Did that help? 3. disconnect battery terminals from battery and use jumper cables to connect to another car's battery. Did the noise stop? 4. is it a factory antenna? make...
Back