I have been looking for a replacement grille for my MSP. Does anybody have one? I know a P5 grille would work too. But, it has to be in great shape. Nothing broken off of it. Even the two mount tabs on each side that it snaps into the bumper cover with. They are on the bottom side of the cover...
I finally did this on my P5 last weekend. It worked absolutley perfect! All 4 speeds work great now and no light flickering of any kind. I hope it lasts.
I had to do that after my cat broke in half. With the single cat pipe I had to weld a O2 bung in right behind the cat so the sensor would not throw a CEL. I also had to extend the wire harness for the sensor. It's pretty far back under there now. But it all works fine now.
I'm interested. These are the same exact ones I have saved on my Amazon wishlist. Let me know how you would like to finish this deal up and I will get it done. Thanks
Richard
It has been wrecked pretty good in the past. The left frame horn is pretty bent up. Somebody did a poor repair. Put a new core support on very poorly and made a sad attempt to straighten the frame horn. They brush painted the core support with yellow paint. Sad. This car was raced hard. Had lots...
Is there any way to tell the difference externally between a MSP transmission and a regular 5 speed from any regular Protege? I have a yellow MSP that is in awful condition. I know it has the wrong engine in it and it does not run. I have no idea if the transmission is correct or not. I have had...
Thanks for the input. This is going to be my daughters first car. Just trying to get all the suspension bugs ironed out. I don't mind doing the work. Thanks.
Just got the P5 back on the road. I have replaced all kinds of suspension parts. Everything was wore out! I bought this back in November and it has had a rough life. The strut mounts are all clunking pretty good. My question is: How difficult is it to change all four top mounts? Can I change...
It is that simple. I was tearing into my 02 P5 Friday night and while I was taking things apart I found that somebody had replaced the bolt and nut that hold the ball joint to the knuckle with the wrong bolt and nut. Not even close to right! The RH side was still right though. So I am looking...
I could not think of the proper name for it. I am looking for the storage box that came in a MSP right under the radio. I am actually looking for two unbroken ones that are in good shape. One to replace the broken one in my yellow MSP and one for my P5. If you have one or two let me know how...
I work at a shop that builds headers. If you had a good one to build a welding jig off of it would be fairly easy to build another one. You would need to come up with new flanges or just clean up the old ones and re-use them. That is fixable. Just finding a good one to make a copy off of would...