Recent content by LuckyMP5

Took me about 20 min to install. Be carefull of the heat shield that you have to move out of the way. Some of the bolts holding it on wouldnt come out and just kept spinning. If it wasnt for that, it would have gone faster.

Most likely a brake issue of some sort. My car had the same issue on the driver side and found that the rotor was partially warped making it squeak against the brake pad. Replaced my brakes and rotors, and was good to go.

Around this area, the sunlight silver is the most popular color. So of course i had to change the color up a little.

Struts: KBR Gr2 Springs: Eibach Pro-kit 1.5" Drop Tires:Kumo Ecsta Asx 195/50/16

Where did you happen to get your egr at? I think i have the same problem and might need to get one.

Looking for any ideas on upgrading the ignition. Anything from spark plugs to coils etc. would help.

I was thinking about running Pirelli p-zero m+s 205/50/16 on the stock p5 16" rims. Has anyone had any experience with these tires? Any opinions would help.

Has anyone experienced check engine light problems when they installed their obx header?

I like doing the work on my car that way i can say that i did it. I figured out how to put most of it in except for the wire that the instructions say i have to connect to the start wire. I found the wire color codes on another thread but it never said what color wire is the start wire. any...

This may seem like a dumb question, but i've never installed a car alarm system before. I have an 03 p5 and i was wondering if i have to cut the wires to install the alarm system or just splice into them? Any advice would help.