Recent content by drock27

Okay well they are all wired positive to postive, negative to negative. I have power. The sub is hooked up. I get nothing loud at all. Maybe I will try getting a new LOC. If that doesn't work then I have a brand new JL 250/1 amp for sale. J/K but I really don't know what I am doing wrong. The...

I think the problem is thewiring to the LOC. If I turn the signal sensitivity knob all the way up I can hear it a little better. If I have left positive to right positive left negative to right negative on the LOC will it make a difference? Are there anyother things that could be holding this up?

If the power light on the amp is lit then my power, ground, and remote wires should all be right, right? So then if the amp is getting power then the problem is in the signal. Does it matter if I have the right wired to the left or vice versa as long as the polarities are correct?

Okay this is killing me. I just picked up a jl 250/1. I cut off the harness, rewired everything, hooked up the sub and still barely no sound at all. LOC adjustment knobs are all the way up. Green power light on amp is lit up. Just no sound. Is the something obvious I am missing or what. I...

If I am reading it right wouldn't that only give the sub 75 watts? If so, I shouldn't even bother right? Amp recommendations? My JL amp isn't coming in for a few days so ifthere is something else that would do a good job too, Icould get it today. JL 250/1? Alpine mono amp?

Hey guys. Just wondering who all on here was aroundthe Cincy area. I have seen someones Pro5 at Tire Discounters on Galbraith. Black with green graphics and it looks like Konig wheels.

75 watts/channel @ 2 ohms 150 watts/channel bridged @ 4 ohms Model is MTX Blue Thunder 752

So that could be the culprit then? Should Inot mess with this amp anymore and and wait for my 500/1? Thanks. Would the amp specs help?

the sub is dual 4 ohms. is there a chance that the amp could be faulty? the are two brown ground wires coming out of the LOC. should those be wired to anything? Thanks.

The only reason I did not do it that way was because I did not think that I could re attach the harness. The adjustment knob on the LOC is all the way up as is the gain on my amp. The sub is an Alpine 12 Type R 4 ohm. It is underpowered now but I was kind of hooking it up for a dry run. The amp...

The factory sub has a harness that holds 8 wires. I disconnected it from the sub itself. I soldered the ends of the line converter to small brad nails and plugged these directly into the part of the harness I unplugged. So total I have 5 wires soldered and plugged intothe harness, right +/-...

thanks for the help guys. i have them all soldered but i can barely hear the sub at all. i'm flustered.

I am running my the signals for my amp from the stock sub harness througha line converter to my amp. Ideally I would like to keep the harness intact, that is not cut off the plastic connector. I have tried repeatedly to twist the wire so that it is snug and then wrapping it in tape. This is not...

Gram Lights are money. They are so money and they don't even know it.

Thanks 1st MP3, I guess a Dremel tool is the best way to scrape the paint. I should be bumpin in no time.