B
big_ben
Hey Mike,
I have one last question about the intake before I start making mine. I can't find the 2.5" rubber sleeve things to connect the intake to the throtle body and to the MAF. All I find is 2" and 3". I even called a plumbing supply store. They said that 2.5" isn't made. Did you just get the 2" and stretch it out or the 3" and just tighten it down? The 3" just looks too big. The guy at the plumbing supply store said I could use a heat gun to heat it and stretch it over the pipe. Will that work? Thanks.
I have one last question about the intake before I start making mine. I can't find the 2.5" rubber sleeve things to connect the intake to the throtle body and to the MAF. All I find is 2" and 3". I even called a plumbing supply store. They said that 2.5" isn't made. Did you just get the 2" and stretch it out or the 3" and just tighten it down? The 3" just looks too big. The guy at the plumbing supply store said I could use a heat gun to heat it and stretch it over the pipe. Will that work? Thanks.
