Search results

I've got the stock MS6 exhaust in the garage but I'm up in the Toronto area of Canada.

I've got 1 brand new one in the box, part #67115, just in case someone needs just 1 (if you busted 1 side for some reason for example).

It will work yes and comes with all the hardware required as shown in the pic as well as instructions... just like when I got it from turboxs.

$100 + shipping.

I've got a practically brand new 3" TurboXS race-pipe ... $100 + shipping from the Toronto area.

I've got 1 too with no broken nipple if that fell through.

$20 to NJ and I'll split it, so $130 total to the paypal address in the orig post and it's yours.

Still available but the lowest I'll go is $120 shipped ... this is practically brand new guys.

Good question ... I checked online and the cat converter costs are different for both vehicles so I'm going to assume it wont.

I'll split the shipping with you which was $20 to Nebraska for a prior quote I did ... Canada Post is down right now but I'm thinking Atlanta might be about the same, so an extra $10 for $130 total.

Yes you can ... it'll remove the stock cat restriction and give you a bit more burble to the exhaust sound.

Anyone??

Bump ...

$120 + shipping from the Toronto, Canada area. Was on the car for only about 250 miles. Paypal address = LBVSVT@yahoo.com.

I'm thinking of selling my 3.25" ETS TMIC ... pressure-tested and fixed a pin-hole ... I think going rate is $450-$475. PM me.

I agree with everything said pretty well but I've had my TurboXS on & off many times and datalogged both it and the stock BPV. What I recall I saw in the logs was the TurboXS would spike about 1-2 psi more than the stocker but also hold 1 psi more in the top-end.

You need a fender roller tool and be sure to get a bunch of washers to put over the studs so the roller can clear the caliper and allow you to go far enough down the side of the wheel well so you roll it as far down as possible. BTW, just need to use the washers when you've done as much of the...

I've got one ... gotta see what going rate is though.

Got an SU rear mount too.

I've got a 3.25" but you know it's gonna cost to ship down under from Canada, right? I'm not sure what going rate is for the TMIC but I think it's $400+.