Search results

First time I had to remove the three point strut brace in eight years, wasn't too bad. Tried the bottom but that wasn't happening. I guess I'll take it to be rebuilt tomorrow

Mine has recently gotten worse, was there a follow up to the light always on question? Also is there an updated switch? For $30 I would buy that.

I'm at 175,000kms and my second (used) alternator just died :( hate this job

*break

Got the parts today and popped it in after work, I thank you again. My tip is to use large zip tie cut in half to open the high pressure fuel fittings. Just use a cut end and slide them in to pop the clips. I had replaced my Phillips screws with hex socket screws many years ago so it came apart...

Great to know, always baffled by the claim of a fuel filter that lasts forever. I put in a Walbro many moons ago and replaced the screws so it "should" come out nicely. Will order these parts ASAP!

BTW, can I pull the IM off without getting new gaskets? Is there a how to somewhere?

Flame much?

Check your PM, I am interested

Wanted $285 new v brace and reinforcing plate. http://www.cipmotorsports.com/mazda25.html

Clutch So, any chance you still have this sitting on a shelf somewhere? (whistle)

Still going great!

The reality of mt\y question was is it skimping? I know most of the aftermarket parts come out of China branded differently so just curious if they are cheaper or just less expensive. I have bought parts direct from China on En\bay that I have been very impressed with the quality.

Brake fluid is nasty stuff and it's leaves a high temp lubricant. I think it'll work well.

Mine was very rough all the time, started 2 days ago. I pulled the plugs and they looked OK but dropped in some fresh Denso anyway. I pulled the EGR and it was stock open. I cleaned it with brake fluid, worked the plunger in and out several times and it started snapping right back the way it...

Depends on your lights, if it has a clear leans it will work. If you did it to your fog lights (which are sealed glass I believe) you would have no reflector left. Here's my tails, obviously not factory tail.

There have always been Forester STi's just never over here :(

what is the feeling on the Ebay timing belt kits? They have kits with tensioners, seals, water pump for around $100-125 + shipping

I couldn't do it, love this car too much to give it up.

I got the polyurethane universal flaps and meant to post my how to and scan/post templates etc. but I got so excited to put them on I just did it. I did use plastic panel clips instead of drilling/screwing. I just removed the stock attachments for fender liners, snapped on a plastic panel clip...