H hozey Member : Mazda protege 2.0 2002 Sep 24, 2012 #1 So i was going to replace my head gasket and i came accross this. Is this normal? Can they be fixed? Any info would be appreciated.
So i was going to replace my head gasket and i came accross this. Is this normal? Can they be fixed? Any info would be appreciated.
Maxx Mazda Resident Asshole Contributor : Completely Stock P5 Sep 24, 2012 #2 I mean short of replacing the head there's really not much you can do. I'd clean them up a bit with some emery paper, and run it.
I mean short of replacing the head there's really not much you can do. I'd clean them up a bit with some emery paper, and run it.
H hozey Member : Mazda protege 2.0 2002 Sep 24, 2012 #3 Well the plan was to have the head machined, but with this thing that came up, would it better to just buy a remanufactured head that comes with the cams, etc.
Well the plan was to have the head machined, but with this thing that came up, would it better to just buy a remanufactured head that comes with the cams, etc.
Maxx Mazda Resident Asshole Contributor : Completely Stock P5 Sep 25, 2012 #4 The cam doesn't have traditional bearings. The cam rides right in the head, so machining them will cause the clearance to be to much.
The cam doesn't have traditional bearings. The cam rides right in the head, so machining them will cause the clearance to be to much.