So I installed a the Mazda Mobile Start this weekend. Everything went fine. Car started perfectly and all functions worked fine. So right before I buttoned everything up, stupid me pulled out the connector to the ECU while power was still applied to the battery (car was off) as I was just inspecting the various connectors on the passenger side.
Now my car will not start up and I suspect it was because of that action. When I go to the driver side to start the car up, foot on the brake, push the ignition button... the engine fails to start. The display cycles through various messages:
I have a 2016 Mazda CX-5 GT. The PN of the ECU is: PE1B-18-9R0R.
I tried disabling the battery several times. going back and making sure the connectors were plugged in good.
I'm guessing I'm going to have to replace the ECU, but figured I'd toss this out here to see confirm and see if there is anything else I should try. Any body replaced an ECU before? Is it simple plug and play?
Now my car will not start up and I suspect it was because of that action. When I go to the driver side to start the car up, foot on the brake, push the ignition button... the engine fails to start. The display cycles through various messages:
- Keyless System malfunction
- Blind Spot Monitor malfunction
- Smart City Brake Support malfunction. Forward SCBS Disabled.
I have a 2016 Mazda CX-5 GT. The PN of the ECU is: PE1B-18-9R0R.
I tried disabling the battery several times. going back and making sure the connectors were plugged in good.
I'm guessing I'm going to have to replace the ECU, but figured I'd toss this out here to see confirm and see if there is anything else I should try. Any body replaced an ECU before? Is it simple plug and play?