yashart_mp3
Member
- :
- Black Mica MS3
bump for answers
yashart_mp3 said:I thought that the back of the block used a 1/8 BSPT thread, and that the standard 1/8th NPT fitting would not fit this thread...
can you point me to exactly what adapter/fitting i need? thanks!
Rogue said:Brian, did you cut your own hose? You ordered the 6ft hose, but had to put the T in the middle for the oil pressure sensor. How did you put the fittings on the end?
Also, what fitting is that you used on the actual block?
Rogue said:another question. how do you attach the fitting to the end of the line after you cut it?
Rogue said:another question. how do you attach the fitting to the end of the line after you cut it?
Rogue said:so it essentially sadwiches the line between the fittings?
Kansei said:hmm that doesn't look bad at all (building the line)
looking over your parts list, I run into some trouble when I want to T off for my oil temp sensor
with the T you used, or the pic on the summit racing site:
I think my temp sensor would block oil flow
see pic here: http://picasaweb.google.com/clauretano/TurboProject/photo#5013267907584279842
it's the bottom sensor in that pic.
JCell said:Damn, i destroyed one of the fitting while trying to squish it in.
there goes 15 bucks
yeah, i had the hose inside the fitting with one turn in only, i got excited and left it there for a second because it was a b**** to get it in at all. a few seconds later it popped out and stripped that first thread, thus it is now useless.Brian MP5T said:Squish?