Rear Strut Bar Installed (pics=56K Death)

A

azeli73

Member

Contributor

:

2002 Protege 5 Turbo

• May 19, 2004

• #1

Well, it came in the mail and my buddy and I didn't wait a minute to start the install. And let me tell you this b**** is tight!!! Took a Dremel to the interior and slowly started cutting away a hole. GT SPEC made a nice bar here. Good quality and the paint finish to the plates are a nice spicy orange.

Butt Dyno proved a BIG difference. Can't wait to get on some twisty mountain roads.

 

Attachments

• 
  R_strut005.jpg

  110.1 KB · Views: 156
• 
  R_strut006.jpg

  87 KB · Views: 117
• 
  R_strut007.jpg

  94.5 KB · Views: 210

Last edited: May 19, 2004

E

element.8

Member

:

2002.5 p5

• May 19, 2004

• #2

how's about focusing the pictures?


i like it, a lot. i'm contemplating this tower bar also, but i definitely will have it powdercoated so its not that wacky ass orange.

 

F

FrigginGLI

Member

Contributor

:

2006 Shadow Blue GLI

• May 19, 2004

• #3

FINALLY SOME PICS! I like !

 

L

L8R

Member

Contributor

:

02' Sport 20/Familia

• May 19, 2004

• #4

nice nice, i take it u cut the plastic to fit the bar through?

 

F

FrigginGLI

Member

Contributor

:

2006 Shadow Blue GLI

• May 19, 2004

• #5

You could also just leave the plastic off if you wish, he used a dremel to make it look nice and tidy.

 

A

azeli73

Member

Contributor

:

2002 Protege 5 Turbo

• May 19, 2004

• #6

I'm going to go back over it with that door edge trim to clean it up some.

 

G

garretts77

Member

:

2007 WRX VF39'd

• May 20, 2004

• #7

how much is that?

 

A

azeli73

Member

Contributor

:

2002 Protege 5 Turbo

• May 20, 2004

• #8

$135 through www.corksport.com

garretts77 said:

how much is that?

Click to expand...

 

J

jersey_emt

Member

:

04 MSM #1089

• May 20, 2004

• #9

I'm contemplating some (or all) of the gt spec products...idk