Thanks guys, I'll be getting the aftermarket. When I found out about the MSP suspension I checked into it but because of the spring perch and the drop it caused in the rear started looking at aftermarket rather than seeing if I could find a junked MSP.
So for the Tokioco HPs and RB springs I'm looking @ 600$ for a new suspension without the misc parts. I know I'm going to need new strut mounts and baffles, but don't know if I'll need anything else. Plan on replacing endlinks, tie rod ends, lower control arms, and sway bar bushings at the same time.
Did I miss any of the suspension bits? The suspension hasn't been touched in the 11yrs since it was made, figured since I was doing the springs and struts might as well replace any other wearable parts/bushings.
So for the Tokioco HPs and RB springs I'm looking @ 600$ for a new suspension without the misc parts. I know I'm going to need new strut mounts and baffles, but don't know if I'll need anything else. Plan on replacing endlinks, tie rod ends, lower control arms, and sway bar bushings at the same time.
Did I miss any of the suspension bits? The suspension hasn't been touched in the 11yrs since it was made, figured since I was doing the springs and struts might as well replace any other wearable parts/bushings.
Last edited: