pillar pod and gauges

boostisgood

Member
:
1988 FC3S TII
My Gauges are in and my pod will be in tomorrow. Wo0t. :D So I wIll have mt Boost gauge and A/F gauge in this weekend. Ill write up an install guide and take pics.

ZooM zOOm
 
Did you get the autometer gauge pod? If so where from im interested in a dual myself but cant find out where to get them. Later
 
www.jegs.com dont know if they still have em but heres the full dual pillar
 

Attachments

  • mp3 boost guage.jpg
    mp3 boost guage.jpg
    59.2 KB · Views: 376
Last edited:
this is a 60mm gauge at daytime in a custom made pod by me!.60mm ownz!
 

Attachments

  • picture 046.jpg
    picture 046.jpg
    51 KB · Views: 311
Last edited:
60mm in itself is metric, so good luck on finding the PSI in 60mm. Now that I accually halfway understand the conversion factor (14.7PSI=1BAR) I think I could live with metric.
 
t3ase said:
I'd like to get a 60mm in PSI, but all I can find is the bar measurement. Any ideas?

Get the AutoMeter 2 5/8 boost gauge. just just like 60mm

Damn Strait 60mm Ownz! Its called peak hold, memory, and warning features!
 
uhh anyone know where i can get a dashmount guage pod? and will it fit on the dash above the center ac ducts? i'm worried that the curve on the dash will cause it not to fit.
 
BoostisGod..

Did you ever write up an install ?

I just bought almost the same setup... boost, a/f and I'm pretty sure I know what I'm doing in terms of install according to the instructions... but your writeup would def help for assurance ;)

Thx!!
 
Back