fail on rear caliber

Hi everyone, I am having problems with my EPB after I change the washers and bricks, brake contact is flashing, unfortunately I have screwed back the stamp which one must not have found out afterwards. What do I do now and can it be saved.

My English is not so good so I have used google translate
 
Maybe - if the parking brake electric motor is not ruined.
Remove the electric brake (2 x bolts).
Rotate the spindle on the back of the caliper counterclockwise.
Reinstall the parking brake electric motor.
Follow the procedure to take it out of maintenance mode:
Pull up on the parking brake switch while holding the accelerator pedal down and cycle the ignition 3 times.


YouTube video link: https://www.youtube.com/watch?v=iXH-deyCgm0
Start the video around 10 minute mark.
 
Maybe - if the parking brake electric motor is not ruined.
Remove the electric brake (2 x bolts).
Rotate the spindle on the back of the caliper counterclockwise.
Reinstall the parking brake electric motor.
Follow the procedure to take it out of maintenance mode:
Pull up on the parking brake switch while holding the accelerator pedal down and cycle the ignition 3 times.


YouTube video link: https://www.youtube.com/watch?v=iXH-deyCgm0
Start the video around 10 minute mark.
 
Thanks for the response. I will try my best when I get home and see if it works but there should be a chance that it will work. I hope, for a new caliber is a costly affair. I'll just have to report back if it's going to work. thanks for the help.
 
Thanks for the response. I will try my best when I get home and see if it works but there should be a chance that it will work. I hope, for a new caliber is a costly affair. I'll just have to report back if it's going to work. thanks for the help.
In addition to excellent suggestion by davmac, you should also read this thread by tomcat1446 if you havent:

Maintenance Mode for 2016/2017 CX-5 electronic brakes
 
Back