Just my MAZDA project stuff

Haha[emoji106][emoji106]

I sent you another check your PM box. ;)
But hey what do I know about anything.....?
Take note under the engine output... :)

The thread is a few pages you need to look at all the pages I posted.
 
Last edited:
I sent you another check your PM box. ;)
But hey what do I know about anything.....?
Take note under the engine output... :)

The thread is a few pages you need to look at all the pages I posted.
Thanks! Tried to access those links, but can't. Membership needed?[emoji53]
 
Thanks! Tried to access those links, but can't. Membership needed?[emoji53]
Well that sucks. I know that it is on a few forums but I looked and they are all in the member user area's. The moderator of that forum passed away leaving no moderator over a year ago. The owner has not been back on to assign a new moderator. The new membership activation has been disabled so there have been no new members on that forum in over a year. To bad because that was a very active forum for new members and such and is also one of the few remaining forums for that plat form on car.
I may just start a thread in the other car part of this forum? It is just a PIA to post all those pictures.
I will picture this.
IMHO a actual functioning CAI for a Skyactive 2.5 Normally Aspirated Engine that will regulate the intake air up to the plastic intake manifold to equal the ambient in most all engine operating conditions. There are parts I am not showing that must be included to make it work. For obvious reasons somewhere in the world people like to copy others design ,market it calling it their own and making money on someone else idea's.(no) Without know what and how the other parts are this is just another "Frankenstein" CAI that you commonly see offered.
[url=https://postimg.cc/zy2nXMV2][/URL](drive2)
 
Hard to think all this wire for 2 simple gauge and 2 switches. All but 3 wires are posted and I have not labeled the wires yet fr the wiring diagram schematic.

I order a replacement dash panel to install the switch panel so I can have everything mounted and then swap out the panel. This work better then pulling the panel and modding and installing the switch panel.

[url=https://postimg.cc/QFJX6MTF][/URL]

[url=https://postimg.cc/f3HMNg5Z][/URL]
 
Nice work, Grendel. Can't wait to see what you do with this thing.
 
Well that sucks. I know that it is on a few forums but I looked and they are all in the member user area's. The moderator of that forum passed away leaving no moderator over a year ago. The owner has not been back on to assign a new moderator. The new membership activation has been disabled so there have been no new members on that forum in over a year. To bad because that was a very active forum for new members and such and is also one of the few remaining forums for that plat form on car.
I may just start a thread in the other car part of this forum? It is just a PIA to post all those pictures.
I will picture this.
IMHO a actual functioning CAI for a Skyactive 2.5 Normally Aspirated Engine that will regulate the intake air up to the plastic intake manifold to equal the ambient in most all engine operating conditions. There are parts I am not showing that must be included to make it work. For obvious reasons somewhere in the world people like to copy others design ,market it calling it their own and making money on someone else idea's.(no) Without know what and how the other parts are this is just another "Frankenstein" CAI that you commonly see offered.
[url=https://postimg.cc/zy2nXMV2][/URL](drive2)

Hope that forum gets revived. The wealth of info there should be shared.
On CAI, have you seen AEM's 2.0 MT specific one?
https://www.aemintakes.com/mobile/product.aspx?prod=21-765C
 
Back