CorkSport.com is MAZDA PERFORMANCE!
CorkSport.com is MAZDA PERFORMANCE!
Results 1 to 3 of 3

Thread: how to replace "plastic tape" around window on rear door

  1. #1
    Registered Member FasterP5's Avatar

    2003.5 P5

    Join Date
    Nov 2003
    Location
    Long Beach, Cali
    Posts
    112

    how to replace "plastic tape" around window on rear door

    see pics ... there appears to be rust bubbles under the "plastic tape" which surrunds the window on my rear door ... how do i fix this ? i assume tht the "plastic tape" will need to be removed in order to fix the rust ? after the rust is fixed, i assume i will need to replace the "plastic tape" ... is this a part which i can get from mazda ? how do i replace the "plastic tape" ?

    connection at home is too slow ... will post pics later today ....

    Attached Images Attached Images
    Last edited by FasterP5; 12-13-2018 at 05:16 PM.
    Wahoo, this car is a hoot !
    '03.5 Silver P5 - "All The Options"
    AEM Short Ram, SR Motorsports Catback, JetHotted AWR Header,
    Eibach Pro Kit.
    Brake Lines sittin' in the garage gathering dust...

    Go Fast, Take No Chances !

  2. #2
    Registered Member

    protege5

    Join Date
    May 2016
    Location
    GA
    Posts
    310
    It's usually called blackout tape. The dealer should be able to order a replacement.

    It can be a real pain to install and not get bubbles underneath it. And if it's not aligned perfectly you have to pull it off, throw it out and start again.

    You'll have to remove the blackout tape. Completely remove and repair the rust underneath it so it is perfectly smooth, and reinstall new blackout tape. Note that any dirt/dust/wavy stuff from bondo not being sanded perfectly flat/etc. will stand out like a sore thumb, just as bad as it does now with the rust bubbles underneath it. And then you would probably want to replace all of the blackout tape on the entire door, and the rear door. Becuase the 1 piece that you replace there with the rust would be brand new black and pretty. The rest of the door around the window, and the back door right next to it would be old, gray, and weathered.


    Personally, I'd just leave it be. Lot of work to fix it so it looks right. If you've got rust creeping there, i'm sure that's not the only place the car has rust.

  3. #3
    Registered Member FasterP5's Avatar

    2003.5 P5

    Join Date
    Nov 2003
    Location
    Long Beach, Cali
    Posts
    112
    thank you pb4ugotobed !

    it is probably the only rust on th car .... it has been in SoCal all it life, and we have owned it since new ....
    Sigs are visible only in your first post on a page. To change your thread display preferences, click here and enable 'Always Show Signature'.

Similar Threads

  1. Why no window "open-all" / "close-all" feature?
    By Aialik in forum CX-5 Lounge
    Replies: 42
    Last Post: 06-22-2016, 01:55 PM
  2. Underhood plastic "stuff"
    By daan in forum Mazda5 Engine & Transmission
    Replies: 3
    Last Post: 01-09-2015, 05:51 PM
  3. Can the "metal" lookalike silver plastic trim on the door be replaced ?
    By pdxa4 in forum CX-9 Accessories & Appearance
    Replies: 8
    Last Post: 03-20-2013, 04:35 PM
  4. Never "wax" your butt with duct tape
    By TStar in forum Lounge
    Replies: 41
    Last Post: 11-25-2005, 02:45 PM
  5. "Color-matched" my valve cover plastic thing
    By derrick1623 in forum Mazda MP3
    Replies: 17
    Last Post: 09-19-2002, 06:50 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •