CorkSport.com is MAZDA PERFORMANCE!
CorkSport.com is MAZDA PERFORMANCE!
Results 1 to 1 of 1

Thread: Creating CorkSport Parts with 3D Scanning

  1. #1
    CorkSport.com/blog CorkSport Blog's Avatar
    Authorized RSS Feed


    Join Date
    May 2014
    Location
    Vancouver, WA
    Posts
    211

    Creating CorkSport Parts with 3D Scanning

    While creating a new CorkSport part, we sometimes run into issues where calipers, bore gauges, and angle finders are simply not enough to get the measurements we need. *We*ve discussed how we use 3D printing in a previous blog, but today I thought I*d go over the opposite: 3D scanning. Where 3D printing takes a * Continue reading "Creating CorkSport Parts with 3D Scanning"



    Please click here for the full article and if you wish, you can post your comments in this thread. Thank you!
    Last edited by CorkSport; 09-25-2018 at 10:32 AM.

Similar Threads

  1. Need a spoilerless trunk for 3D scanning
    By tvanryn in forum Mazda6 Accessories & Appearance
    Replies: 9
    Last Post: 02-27-2014, 12:37 PM
  2. what's the deal with scanning an rx8
    By 04spoondc5 in forum Rotary Mazdas
    Replies: 6
    Last Post: 02-07-2013, 12:31 PM
  3. Help needed creating a detailing kit...
    By AODfan in forum Mazda How-To
    Replies: 30
    Last Post: 04-14-2010, 09:11 AM
  4. creating igoogle gadget?
    By kickniteasy in forum Off Topic
    Replies: 1
    Last Post: 05-29-2009, 03:35 PM
  5. creating gif's
    By the orracle in forum Off Topic
    Replies: 2
    Last Post: 06-11-2005, 07:25 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •