Creating CorkSport Parts with 3D Scanning

While creating a new CorkSport part, we sometimes run into issues where calipers, bore gauges, and angle finders are simply not enough to get the measurements we need. *We*ve discussed how we use 3D printing in a previous blog, but today I thought I*d go over the opposite: 3D scanning. Where 3D printing takes a * Continue reading "Creating CorkSport Parts with 3D Scanning"

Mazdaspeed3-Front-Lip-Scan.jpg


Please click here for the full article and if you wish, you can post your comments in this thread. Thank you!
 
Last edited by a moderator:
Back