- :
- Mazda P5
So I hit a snag, I just bought a MSP lip and I put 3m double sided tape on it, same as my wing but it's not staying flush around the bumper curve on both sides next to the fog light.
I've used lots of pressure to push them together they stayed until the following day I went out and its sticking out a bit. When I push them together again for approx 30 seconds and it stays together until I drive. Is there somethi g I'm doing wrong? I see everyone else's setup completely flush.
Is there like light glue or apoxy I should use?
I've used lots of pressure to push them together they stayed until the following day I went out and its sticking out a bit. When I push them together again for approx 30 seconds and it stays together until I drive. Is there somethi g I'm doing wrong? I see everyone else's setup completely flush.
Is there like light glue or apoxy I should use?