2001 SE Build

WingingIt

Member
:
2001 Mazda Miata SE BRG
Hello, all. I've recently purchased a miata in rough shape and I was looking for a fun project car as I'm finally at a place in my life where I can work on one. I guess I'll start at the beginning.

I purchased the car for a good deal and took it home doing 30mph. The front wheels were pointing in different directions but somehow I made it home. It looks sharp though and already has a hardtop. Just needs some love.
125d091140c0253d3324468364b48dba.jpg
1c836c5fe219a242d631443f7b00792f.jpg
22ffb3f5ad6eed6d15e15fcaed7c3eb4.jpg
 
So the front wheels were pointing in 2 different directions. I drove the car to an alignment shop only to have them turn me away because my control arm bushings were shot. Had to drive back home and hope a tire didn't pop. When I made it, the metal wire had been worm through in a spot and the tire was bulging. I spent the next 2 weeks replacing upper and lower control arms. I destroyed the tie rod ends getting them out so I repacked those as well. The ball joint boots were trashed anyway so it was good to replace those as well. Between seized tie rods and control arm ball joints, I went through a few tools and broke some things. Coilovers will come eventually. For now, I just want to drive it straight down the road.
f32a4521eb5828d9a6cabc110868c713.jpg
01a141de4ff7f908dda77090dd7c72aa.jpg
469b3cbf28afab96e347db3bfd66d30b.jpg
9a77d1004efa57df9824a5874203b319.jpg
1140c47519e62a42dbebf5c6daa56f21.jpg
94befed9da205e0df82e8af0f07dce9c.jpg
 
This brings us to the current state.

The front wheels are now much straighter. I ordered two 15X8 konig dial in wheels for now. Once those come in, I'll put some tires on them and rotate my back wheels to front, new wheels to rear so I can take it to get aligned. I'll get the other two wheels in time. Too much money at once so I've got to break it up.

My parking brake is still in need of repair. It will engage when pulled up but not lock out. I have the release button but it's not attached. I can see a thin rod inside of it but it won't reach out enough to screw in the release. Does anyone have any experience with the handbrake assembly?

I'm also thinking of removing the dash in order to remove the carpet so I can detail the car completely. The car is filthy in it's current state. I pulled the center console to follow some poorly ran amplifier cable and it was disgusting underneath. I'm sure removing the dash will be a nightmare but it will give me a chance to learn the car through and through. I'm trying to see the positive!
5fe7528e056e004c1fe390e0a1fb8dd3.jpg
 
Last edited:
New steering wheel went on with nrg hub and quick release. 2 wheels arrived. I'll see if I can get tires here by the weekend
bb2cc0da277c51d47891d27176e12fbf.jpg
7ce6a82155f5c1ee105bd0511f555d40.jpg
3245e353fe38c730623b7b74761e188a.jpg
 
Back