I'm in the process of installing a pioneer AVH-2300nex in place of the factory headunit in my 2013 cx-5 touring. I'm using the metra mazcam-6v adapter to make it so that I can keep the factory rear view camera. My only issue is determining which wire on the factory harness that goes to the headunit is the reverse signal wire. I saw some posts on some of the Mazda 6 forums indicating that it was the white wire with a red stripe but I wasn't sure if this would be the same.
I'm using the Metra 70-7903 to go in between the factory harness and the pioneer harness. The mazcam-6v adapter is being used for the backup camera. Any help would be appreciated.
I'm using the Metra 70-7903 to go in between the factory harness and the pioneer harness. The mazcam-6v adapter is being used for the backup camera. Any help would be appreciated.