No Instrument cluster diagnostic lights

RCombs

Member
:
2003 Mazda 6 3.0L V6
When I turn the key to start the car I don't get any of the diagnostic lights.
I didn't realize it until after I bought the car.
Everything seems to run alright. I checked all the fuses under the steering wheel and under the hood, nothing blown there...
6d1a8d629592a61b050dcebf918410c9.jpg


Sent from my SM-G930P using Tapatalk
 
Pull the cluster out and check the connectors. I am assuming the gauges work properly?

Two screws at the top and pull the clips on the bottom to remove the bezel
Three screws to pull the whole cluster.

Instrument Cluster User Diagnostics


1. Insert car key into ignition
2. Press and hold Odometer Trip Reset switch on the instrument cluster
3. Turn car key to the ON position
4. Wait 4 seconds until you see the words "TEST" displayed on the instrument cluster
5. Let go of the Odometer Trip Reset switch

Pressing the Trip Reset button will now cycle through a series of diagnostic tests.

The following DTCs (Diagnostics Test Codes) will be displayed with each press of the
Trip Reset.


DTC
Display
Test Description


01
On/Off
Drive side Seatbelt engaged/disengaged

04
On/Off
Door open, door close

08
TNS relay
Lights on reminder buzzer - requires relay access to test

12
Speedometer
Performs a full Speedometer sweep from 0 to Max then comes to rest at 60kph or 37 mph

13
Tachometer
Peforms a full Tachometer sweep from 0 to Max them comes to rest at 3K rpm

14
On/Off
Tests instrument cluster buzzer sound

16
On/Off
Cycles On/Off and fuel warning light

18
On/Off
Flashes Ignition key illumination on/off

22
Numeric
Displays fuel sender's current fuel level

23
Fuel guage
Performs a full sweep of the fuel empty/full guage

25
Temp guage
Performs a full sweep of the engine temperature guage

26
LED
Full LCD illumination test

31
Key reminder
Displays key position

Lets hope 26 makes you look like this.
211570d1509508912-help-my-check-engine-light-missing-mazda-6-2004-instrument-cluster-web.jpg
 
Back