- :
- Mazda Mazdaspeed Protege
Hello all, I'm at my wits end and this forum is where I got much of my info for my build. Story is I bought #81 a year ago and have been working on it in my spare time. Anyways, bought it with a faulty rebuilt engine and it blew on the drive home. New/rebuilt engine, rebuilt trans, Tein suspension kit. Went to try and start it and it would crank and then a wire from the block going to the ground near the top of the strut tower melted. After that, nothing I would do could get it to crank again. Engine 10a fuse keeps blowing anytime I turn to ignition, thought it was the ecu but I get the same issues with a swapped ecu. I also get the temp gauge pinged at hot, oil pressure warning light, abs warning light, and check engine light. I'm not sure where to go from here and I desperately need assistance!! Thank you for reading my post!