So, I got bored the other night and was surfing EBay- never a good thing, lol. I ordered some LED "switchback" bulbs- they flash amber, and then change to white parking lights. From what I've read, the ECU controls the turn signals, and will not recognize the LED's- they will "hyperflash" because their current draw/resistance is so much lower than the incandescent bulbs being replaced. The solution provided by the seller is to install 6 ohm resistors between the turn signal hot wire and the ground. Other than this bulb fixture being a total b**** to get at, which wires am I installing the resistor on? I suppose the better question would be- anyone have the wiring diagram for a 2010 Mazda 5 Grand Touring?