bumper cover is mounted assembly

BigFish246 · Jun 20, 2015

Hi, I need to see how the bumper cover is mounted on the the fender. This is the area in the wheel well. Anyone have a picture or something that I can see what parts are needed and how to assemble. Thanks in advance, bigfish246.

Charcoal · Jun 28, 2015

I used the fog light accessory instructions to remove and install my front bumper. There is a link on this thread.
http://www.mazdas247.com/forum/showthread.php?123655215-Fog-Light-Instructions
I looks like you might need a "bumper slider"? and some bolts.

icspots · Jun 30, 2015

there are three clips on the bumper cover which slide into holes along the seam where it meets the fender. Then there's a single bolt in the upper rear corner of the bumper cover which goes straight up (looks like you have that spot pictured there). AFAIK the bolt is the same as the ones which hold the lower engine cover to the bottom of the bumper cover. That's all that holds it along the fender.

bumper cover is mounted assembly

BigFish246

Member

Charcoal

Member

icspots

Paramagic

Similar threads

Latest posts