There appears to be an open circuit in the DSC/RSC system wiring. Have looked at the workshop manual but can't clearly understand the instructions shown in the attachment.
If I want to test the continuity in LR speed sensor, should I connect one of the multimeter leads to terminal F and the other to terminal B?
To do an ohm reading on the LR ABS sensor, should I connect the leads to terminals F and I (i) ?
Besides disconnecting the battery, any other precautions I need to take?
If I want to test the continuity in LR speed sensor, should I connect one of the multimeter leads to terminal F and the other to terminal B?
To do an ohm reading on the LR ABS sensor, should I connect the leads to terminals F and I (i) ?
Besides disconnecting the battery, any other precautions I need to take?
Last edited: