I have an exhaust leak in my P5 that I've diagnosed to be coming from where my OBX header meets the SLS midpipe
Put a new donut gasket on when I installed them both maybe 6 months ago
Anyways I went to NAPA and bought the generic studs, springs, washers, and bolts for a mazda. The springs are fully compressed and I can't go any tighter. I think this is why its leaking
Just called the Mazda Dealership and the guy said it would be $63 for 2 of each of the following: Stud, Spring, Washer, Bolt
Wondering if I'm supposed to get 4 nuts and 4 washers, though.
I've been trying to find a diagram to see the part numbers. I placed an order over the phone and they were very rude and wouldn't give me the part numbers.
Anybody have a diagram and know the part numbers? Thanks 2003 mp5
Put a new donut gasket on when I installed them both maybe 6 months ago
Anyways I went to NAPA and bought the generic studs, springs, washers, and bolts for a mazda. The springs are fully compressed and I can't go any tighter. I think this is why its leaking
Just called the Mazda Dealership and the guy said it would be $63 for 2 of each of the following: Stud, Spring, Washer, Bolt
Wondering if I'm supposed to get 4 nuts and 4 washers, though.
I've been trying to find a diagram to see the part numbers. I placed an order over the phone and they were very rude and wouldn't give me the part numbers.
Anybody have a diagram and know the part numbers? Thanks 2003 mp5