hello the title says most of it, im looking to replace my rear o2 with a wide band so i can also hookup a wide band gauge and not get any codes
rear o2 sensor wire
G/R - pin 93 - heater On/Off
Y/L - pin 35 - O2S12 Rear
O - pin 91 - Ground
B/L - pin 26 - ignition timing
Bosch 17025 A/F sensor
Red - IP
Black - vs
Yellow - vs/ip
white - H-
grey - H+
this is what i found out from the internet diagram. can someone please tell me what wire goes to what wire?
rear o2 sensor wire
G/R - pin 93 - heater On/Off
Y/L - pin 35 - O2S12 Rear
O - pin 91 - Ground
B/L - pin 26 - ignition timing
Bosch 17025 A/F sensor
Red - IP
Black - vs
Yellow - vs/ip
white - H-
grey - H+
this is what i found out from the internet diagram. can someone please tell me what wire goes to what wire?