I bought these as a little project. Two had some curbrash that I have repaired. I filled the deeper curb with JB Weld Steel and then sanded it down flat. I went ahead and sanded the whole wheel too so I would think it's ready for PC or paint. The other two wheels have very light curb that I don't think needs filling. The two that I have repaired do not have tires, but the other two have really bad tires on them -- not useable. Three of the four have TPMS sensors installed, one does not. I have all center caps as well.
I'm not going to play it off like these are spotless rims. They've been used and they look it, but with PC or paint they should look respectable. I'm not asking premium money for these.
Wheel #1
Wheel #2
Wheel #3 (repaired w/ TPMS)
Wheel #4 (repaired no TPMS)
Price:
$300 (+ shipping)
Local pickup preferred. Drop off in Kansas City is an option.
Glendale_Powder_Coating said:Can you powder over bondo?
It is not recommended. The Bondo tends to out gas which gives it little bubbles. Metal Lab or JB weld is a better choice, if you must use a filler.
I'm not going to play it off like these are spotless rims. They've been used and they look it, but with PC or paint they should look respectable. I'm not asking premium money for these.
Wheel #1
Wheel #2
Wheel #3 (repaired w/ TPMS)
Wheel #4 (repaired no TPMS)
Price:
$300 (+ shipping)
Local pickup preferred. Drop off in Kansas City is an option.