- :
- 06 LS MS6
07 BM GT (shell has been struck from the roll)
WOW,
what a PIA this gig was
THANKS to C T B B
for providing accurate part numbers
this job would take 10 minutes if the engine was laying on its side on the kitchen table. ( were single guys work on engines )
the tensioner is a b**** to work with. you need a patient helper
the idler is a huge pain to remove
there is even a slot to slide the bolt back into, cuz it is longer than the gap between the engine and the frame
the belt is not super easy to get back on either
I need a beer
what a PIA this gig was
THANKS to C T B B
for providing accurate part numbers
this job would take 10 minutes if the engine was laying on its side on the kitchen table. ( were single guys work on engines )
the tensioner is a b**** to work with. you need a patient helper
the idler is a huge pain to remove
there is even a slot to slide the bolt back into, cuz it is longer than the gap between the engine and the frame
the belt is not super easy to get back on either
I need a beer