Fender rolling

K

kbzon01

Member

:

2008 Mazdaspeed3 GT Black Mica

• Dec 18, 2009

• #1

I have already used the search engine and not completely satisfied with my results.

My car goes in to the body shop next week for hail repair and figured I would get fenders rolled while its there. Can someone post close-up pics of their fender roll? Especially where fender meets rear bumper and where fender and lower side lip meet???

I may just dremel/grind off. It just seems easier and more straight forward IMO...(help)

 

M

mazdaspeedster3

Member

:

Mazdaspeed3. 2008

• Dec 18, 2009

• #2

Rolling the fender really isnt that big of a deal. You are only rolling that inner lip of the wheel well. Grab a bat and have at it. Heat it up though first, makes it a lot easier.

 

K

kbzon01

Member

:

2008 Mazdaspeed3 GT Black Mica

• Dec 18, 2009

• #3

Wooden bat i am assuming? lol

 

M

mazdaspeedster3

Member

:

Mazdaspeed3. 2008

• Dec 18, 2009

• #4

Sure... Are you really getting rubbing?

 

K

kbzon01

Member

:

2008 Mazdaspeed3 GT Black Mica

• Dec 18, 2009

• #5

no, but i want to change my wheel setup sometime in the future. I was looking at 18x8 +35 offset and figure since my car would be in the body shop...

 

M

MSP300

Member

:

mazdaspeed3

• Dec 18, 2009

• #6

there suppose to be some pics on this thread
http://www.mazdas247.com/forum/showthread.php?t=123760234
but im gonna roll my fenders next week when i get the tool an will post some pic

 

K

kbzon01

Member

:

2008 Mazdaspeed3 GT Black Mica

• Dec 18, 2009

• #7

MSP300 said:

there suppose to be some pics on this thread
http://www.mazdas247.com/forum/showthread.php?t=123760234
but im gonna roll my fenders next week when i get the tool an will post some pic

Click to expand...

Yeah, I took a look at that one too... Thanks!

Good luck with the roll and post up the pics when you can!!!(wiggle)