Well as I was looking for end links because the Ksports coilovers and the stock end links are way off, I decided to make my own. (Too cheap to pay for the AWR ones) Anyways I went looking around and found McMaster.com. With that and some parts from a local hardware store I completed my own set of sway bar end links. Oh BTW if you decide to do this and something gets messed up..You are at your own risk. lol (gotta do that to save my butt)
Parts from Mcmaster
$5.39 eachQTY 4 2458K341 Carbon-fiber Race Ball Joint Rod End, 3/8"-24 Female
Parts from Local Hardware Store
$0.12 each Qty 16 3/8 Rubber O-ring
$0.30 each Qty 8 3/8-24 (fine thread) nuts grade 8
$0.30 each Qty 4 3/8 lock washers
$2.00 Foot Qty 1 (36In) 3/8-24 (fine thread) Threaded rod Grade 8
This is what it looks like assembled.
I ended up using two O-rings on the inner side because the ball joint was hitting the bracket.
This is what it looks like installed.
Picture on the other side
Close view of the upper
Close view of the lower
As for driving impressions. I did not hear any noises or anything like that. So far its been great. Feels good too.
So if there is any questions just let me know.
Thanks for looking!
Parts from Mcmaster
$5.39 eachQTY 4 2458K341 Carbon-fiber Race Ball Joint Rod End, 3/8"-24 Female
Parts from Local Hardware Store
$0.12 each Qty 16 3/8 Rubber O-ring
$0.30 each Qty 8 3/8-24 (fine thread) nuts grade 8
$0.30 each Qty 4 3/8 lock washers
$2.00 Foot Qty 1 (36In) 3/8-24 (fine thread) Threaded rod Grade 8
This is what it looks like assembled.
I ended up using two O-rings on the inner side because the ball joint was hitting the bracket.
This is what it looks like installed.
Picture on the other side
Close view of the upper
Close view of the lower
As for driving impressions. I did not hear any noises or anything like that. So far its been great. Feels good too.
So if there is any questions just let me know.
Thanks for looking!
Last edited: